VEVOR YP-9 Manual Metal Bender: capacity, dies and who it suits

The VEVOR YP-9 is a manual bender for cold-bending solid round and square steel bar and flat stock. It uses a long handle and interchangeable dies instead of a motor or hydraulics, and VEVOR positions it for metalworking, repair and construction tasks. Here is what the specifications mean.

How a manual bender works

A manual bender holds the metal against a die, or former, and uses leverage from a long handle to push it into a curve. The die sets the inside radius of the bend, so the same bar can be bent into tight or wide curves just by changing dies. Because it works cold, there is no heating involved, which is common for mild steel in smaller sections. The handle on this model is 44 inches long; a longer handle generally means more leverage and less effort for a given bend.

The seven round dies

VEVOR supplies seven round dies in these sizes: 1", 1-1/4", 1-1/2", 1-3/4", 2", 2-1/2" and 3". The listing also describes them as reinforced steel. Choose the die whose size matches the curve you want. A smaller die gives a tighter bend, and very tight bends are more demanding on both the metal and the user. There are four 5/8" mounting holes, and the package includes two fixing pins and four fixing screws.

Capacity: what it can bend

VEVOR gives the maximum stock width as 1-15/16" and the maximum stock thickness as 5/16". The stated capacity in mild steel is 5/16" x 1-1/4" or 1/4" x 2" flat bar. The listing also says the tool bends solid round and square bars. Mild steel is softer and easier to bend than stainless or hardened steel, so treat these as figures for mild steel; harder metals will bend less easily and may be beyond the tool's stated capacity.

Mounting and weight

The tool weighs 32 lb, and the four mounting holes let you fix it to a solid workbench or stand. Bolting a bender down is typically important, because the force of a bend pushes back on the tool. VEVOR does not list dimensions in this listing.

What people make with it

VEVOR lists grids, gates, balcony railings, patio furniture, iron lamps and construction or repair projects. Typical uses include scrolls and curves in ornamental ironwork, brackets and frames.

Who it suits

It suits fabricators, DIY metalworkers, hobbyists and small repair shops that need repeatable curves in bar stock without power tools. It is less suited to high-volume work, thicker or harder stock, or tight bends in large sections.

What to check before you buy

• Stock size and type: compare your material's width, thickness and grade with the stated mild steel capacity.
• Die size: make sure the radius you need matches one of the seven dies.
• Mounting: plan a very sturdy bench or stand and use the mounting holes.
• Workspace: a 44-inch handle needs room to swing.
• Safety: wear gloves and eye protection, keep hands clear of pinch points and follow the manual.
• Upkeep: check the manual on lubricating moving parts and keeping dies free of debris.

The short version

• Manual bender for solid round and square bar and flat stock, with a 44-inch handle.
• Seven round dies from 1" to 3"; four 5/8" mounting holes.
• Rated for 5/16" x 1-1/4" or 1/4" x 2" mild steel; maximum stock 1-15/16" wide and 5/16" thick.
• 32 lb; includes two fixing pins and four fixing screws.
• Bolt it down, and check your material against the capacity.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.