VEVOR 30-Inch Box and Pan Brake: features, specs and who it suits

The VEVOR W1.2×760 is a 30-inch box and pan brake, a hand-operated tool for folding sheet metal into straight, crisp bends. It is meant for workshops that make brackets, trays, flashing, enclosures and similar parts, where cutting and folding by hand is more practical than sending the work out.

What a box and pan brake does

A sheet metal brake clamps a sheet along a line and lifts one side of the sheet upward around a bending edge, forming a fold. "Box and pan" brakes have a segmented upper clamp, which in general lets you make four-sided boxes and trays by folding in the sides. The VEVOR listing describes straight-line bending of sheets up to 30 inches (about 760 mm) wide, and presents it for personal workshops and small-scale fabrication.

Materials and thickness

VEVOR says it handles mild steel, stainless steel, copper and aluminium, and that it bends 18-gauge (1.2 mm) mild steel, thanks to a bending blade 0.3 inches thick. The model number, W1.2×760, reflects that 1.2 mm capacity and 760 mm width. As a general rule, thicker or harder metals need more force, so softer materials such as aluminium and copper typically allow somewhat heavier gauges than steel does, and stainless is usually the demanding one. Stay within the rated capacity; forcing a thicker sheet can damage the tool or the work.

Adjustable angles

The bend angle can be set from 0° to 135°. VEVOR says this gives consistent, precise angles. Metal springs back slightly after bending, so many people overbend a little to reach a target angle, and a few test bends on scrap will show how your material behaves.

Clamping and stability

The clamping bar is built in, so there are no loose clamps to lose. Pre-drilled mounting holes let you bolt the brake to a workbench, which VEVOR says gives stable, wobble-free operation. A bolted-down brake is generally easier and more accurate to use than one that shifts on a table. Operation, according to VEVOR, is simple: tighten the side screws to secure the sheet, then lift the handle to the angle you need.

Size and weight

It measures about 35.8 x 17.7 x 4.3 inches (roughly 91 x 45 x 11 cm) and weighs 45.9 lb (about 21 kg). That is light enough to move around a workspace but heavy enough to feel planted when bolted down. VEVOR calls it portable, and the aluminium construction is a factor in that.

Who it suits

It suits hobbyists, small fabricators, HVAC and roofing tradespeople making small parts, and anyone building enclosures, trays or custom brackets. It is less suited to production work with thick plate or sheets wider than 30 inches.

What to check before you buy

• Your material and gauge: confirm your most common sheet falls within 18-gauge mild steel or thinner.
• Sheet width: measure the longest fold you need against the 30-inch limit.
• Bench space: you'll want a sturdy bench that you can drill and bolt into.
• Edge details: think about whether you need hems or very tight radii, which a basic brake may not produce.
• Protective gear: cut sheet edges are sharp, so gloves and eye protection are standard practice.
• Upkeep: keep the blade and clamping surfaces clean and free of metal chips, and follow the manual.

The short version

• A 30-inch box and pan brake for folding sheet metal by hand.
• Rated by VEVOR for 18-gauge (1.2 mm) mild steel, plus stainless, copper and aluminium.
• Adjustable bend angle from 0° to 135°.
• Integrated clamping bar and pre-drilled holes for bolting to a bench.
• About 45.9 lb; aimed at workshops and small-scale fabrication.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.