VEVOR TR60A Manual Tube Roller Bender with 6 Dies: specs and who it suits

The VEVOR TR60A is a manual tube and pipe roller bender. It uses a hand crank to roll round tube, square tube, solid round bar and flat bar into curves, and it comes with six dies. It is aimed at workshops, HVAC and metal fabrication work, where a curve is needed along the length of a piece instead of a single sharp bend.

How a roller bender works

A roller bender passes the material between rollers that press it into a curve. Turning the crank moves the piece through, and adjusting the roller position changes how tight the curve becomes. This differs from a lever-style bender, which makes one bend at a point. Rolling is typically used for arcs, rings and gentle curves, and the listing gives the maximum bending angle as 360 degrees.

Capacity

VEVOR lists these limits:

• Diameter: tube up to 1-1/2 inches.
• Steel: low-carbon steel under 0.08 inch (about 2 mm) thick.
• Aluminum: under 0.16 inch (about 4 mm) thick.
• Materials: steel, iron, copper and aluminum.

Wall thickness matters as much as diameter. Thicker or harder material takes more force and may exceed what a manual machine can do, so stay within the listed limits.

The six dies

Dies are the shaped rollers that hold the tube so it doesn't flatten or kink. Six come in the set: three for square pipe and three for round pipe. VEVOR says they cover flat bars, round pipes, square pipes and solid round bar. Matching the die to your tube size and shape is the key to a clean curve.

Build and handling

The frame is carbon steel, described as durable, wear-resistant and strong. A manual crank gives control over how fast the piece moves. The machine is compact, at about 29.5 x 12.6 x 14.0 inches (75 x 32 x 36 cm), but it weighs 72.3 lb (about 33 kg), so plan how it will be mounted or moved. Bolting it to a sturdy bench or stand is typical for tools of this type; follow the manual.

Who it suits

It suits HVAC technicians, auto repair shops, metal furniture makers, fabricators and DIY builders making things like frames, handrails, roll cages or curved supports. VEVOR also lists air conditioning maintenance, construction sites and piping maintenance.

What to check before you buy

• Tube size and wall thickness: compare them with the 1-1/2 inch and 0.08/0.16 inch limits.
• Shape: confirm the dies cover your round or square profiles.
• Bend radius: check the manual for the tightest curve and how springback affects it.
• Mounting: plan a solid bench or stand for a 72 lb machine.
• Material: soft metals such as copper and aluminum bend more easily than steel.
• Protective gear: wear gloves and eye protection when handling metal.

The short version

• A manual crank roller bender, model TR60A.
• Handles tube up to 1-1/2 inches, 360-degree bending.
• Six dies: three round, three square.
• Steel under 0.08 inch and aluminum under 0.16 inch thick.
• Carbon steel frame; 72.3 lb.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.