VEVOR DLSSC4 Commercial Hand Sink: features, specs and who it suits

The VEVOR DLSSC4 is a small stainless steel hand sink with a faucet and raised splashbacks, made for walls where space is tight. It gives a restaurant, bar, workshop or garage a dedicated place to wash hands, rinse tools or clean produce without a full-size sink. Here is what its features mean and what to confirm before fitting one.

What you get in the basin

The sink is a compact unit of about 17 x 12.8 inches (roughly 43 x 33 cm) across the bowl, according to VEVOR's naming. The overall package is listed at 15 x 17 x 13 inches and weighs 14 lb (about 6.4 kg), light enough for one person to lift into position. A stainless steel basket strainer and drain assembly come with it, which catches debris before it reaches the pipe and helps prevent clogs.

Why three splashbacks matter

A hand sink is usually mounted close to walls and cabinets, and water bounces off the bowl when taps run at full flow. VEVOR fits three high splashbacks, which protect surrounding surfaces from water and keep the area drier. In practice, that means less wiping and less moisture creeping into the wall behind the sink, a common concern in busy kitchens.

Stainless steel construction

VEVOR describes the sink as made from durable, rust-resistant stainless steel. Stainless is common in food service because it is hard-wearing, doesn't absorb liquids and wipes clean. Grades and thickness differ between products, so check the listing and the manual if you need a particular specification.

The faucet and ceramic valve core

The faucet rotates through 360 degrees, so you can swing the spout to wash hands, fill a container or rinse food. Inside is a ceramic valve core. VEVOR says it prevents leaks and cuts water waste compared with rubber seals. Ceramic cores are generally valued because they resist wear over many open-and-close cycles.

Installing it

All the parts needed to install the sink are included, VEVOR says. You can mount it on a wall or set it into a surface (an embedded installation), which gives flexibility if you are working with a counter, a bench or a bare wall. Wall mounting means the fixings must suit the wall type, such as masonry or studs, and must carry the weight of the sink plus the water in it. The supply and waste connections should follow local plumbing codes and the manual.

Where it fits

VEVOR lists hand washing, tool cleaning and produce washing as uses, in commercial kitchens, laundry rooms, bars, garages, gardens and workshops. It suits places that want a separate hand-wash point and have limited room. Food businesses often have local rules about hand-wash stations, so confirm what your area requires before choosing a unit.

What to check before you buy

• Local requirements: if the sink is for a food business, check whether your health authority sets rules on hand-wash stations, such as hot water supply.
• Space: measure the wall width, the height you want and the clearance around the faucet.
• Plumbing: confirm you have supply and drain connections within reach, and the fittings you need.
• Wall strength: make sure the wall or support can carry the sink and water load.
• What's in the box: check which fittings, strainer and hardware are included against what your installation needs.
• Upkeep: stainless steel is easy to wipe down, but check the manual for cleaners to avoid.

The short version

• A compact stainless steel hand sink, model DLSSC4, weighing 14 lb.
• Three high splashbacks, a basket strainer and a drain assembly.
• A 360-degree rotating faucet with a ceramic valve core.
• Wall-mounted or embedded installation, with installation parts included.
• Aimed at kitchens, bars, laundry rooms, garages and workshops.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.