VEVOR 12 Ton H-Frame Hydraulic Press: features, specs and uses

The VEVOR 12-ton hydraulic press is a floor-standing H-frame press for workshop jobs that need a lot of controlled force. It is aimed at home mechanics and small workshops that press bushings, bearings and joints in or out, and that straighten or bend metal parts.

What 12 tons of force is for

A hydraulic press multiplies a small effort on a handle into a large force along a ram. VEVOR describes this one as suited to removing and installing automotive bushings, bearings, ball joints, U-joints, pulleys and gears. It also lists metalworking tasks such as bending, straightening and stamping. Twelve tons is a typical capacity for a home or small-workshop press: enough for many automotive parts, though stubborn or very large components may call for more.

The H-frame and its base

The frame is shaped like the letter H, a common press design in which two uprights carry a cross beam and the working table. VEVOR says the body is 0.2-inch carbon steel with a powder-coated finish that resists corrosion and wipes clean. The base uses a triangular structure that VEVOR says gives extra stability so the press doesn't wobble or shake under load.

The press is a long, heavy item: the listing gives about 54.3 x 9.5 x 4.9 inches and 86 lb, so it's likely shipped in pieces to be assembled at home.

Relief valve

The hydraulic jack has a built-in relief valve. VEVOR says it opens automatically when pressure goes past 12 tons, which is meant to prevent overpressure damage to the workbench and the press. A relief valve is a standard feature on hydraulic equipment, but it doesn't replace staying within the rated load or using sound technique.

Adjusting the working height

The working range runs from 1.6 to 27.8 inches (about 4 to 70 cm). You change the table height with a pin system, moving the support to a different set of holes to suit the part. Taller parts, such as a shaft with a pulley, sit lower down; thin parts sit higher so the ram has less distance to travel.

Two movable stamping plates come with the press. VEVOR says they are for securing small parts while you work, and they also give a flat surface to press against.

Who it suits

It suits hobbyist mechanics doing suspension and wheel-bearing work, small repair garages, and DIY metalworkers who need bending or straightening. It will fit anyone with floor space and a sturdy, level surface.

What to check before you buy

• Rated capacity: compare 12 tons to the parts you need to press, especially large bearings.
• Size of your parts: check the 1.6 to 27.8 inch range against the length of the work.
• Floor space: plan for a level floor and room to work around the press and handle.
• Assembly: expect to build the frame and base from the parts supplied, and follow the manual.
• Hydraulic upkeep: ask how to check fluid level and bleed air, and what the manual recommends.
• Personal protection: pressed parts can shift or break. Use eye protection and follow the manual's guidance.

The short version

• A 12-ton floor-standing H-frame hydraulic press for bushings, bearings, ball joints and U-joints.
• 0.2-inch carbon steel body with a powder-coated finish and a triangular base.
• Built-in relief valve for pressure above 12 tons.
• Pin-adjustable height from 1.6 to 27.8 inches, with two movable stamping plates.
• About 86 lb; follow the manual for assembly and use.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.