DEWENWILS DL-600A3 30ft Retractable Metal Cord Reel: specs and uses

The DEWENWILS DL-600A3 is a compact retractable extension cord reel with a metal housing. It gives a garage or workshop a pull-out power point of about 30 feet in total, hung from the ceiling or a wall so the cord stays off the floor.

How the 30 feet add up

The name says 30 feet, and the listing explains the split: a 26-foot SJTW extension cord and a 4-foot lead-in cord. The lead-in is the short section running from the reel to the outlet. The extension cord is the part that winds in and out. The cable is 16/3C, which means 16-gauge wire with three conductors including a ground. A 16-gauge cord is lighter and more flexible than a 14-gauge one, and is typically used for lighter loads, which matches the 10A limit.

Retraction without the tangles

An auto-guide rewind mechanism retracts the cord quickly and smoothly, and DEWENWILS says it avoids kinks and tangles. A ratchet system locks the cord at any length you choose. One detail to note: the stopper is not adjustable. The listing says this effectively prevents the cord from fully retracting into the reel. In practice, the cord's end stays accessible rather than disappearing inside.

Swivel mount

The reel has a swivel mounting bracket that moves freely through 180 degrees. It can hang from a garage ceiling or fix to a wall, and the cord can be pulled from different directions. Overhead mounting frees up work space and cuts down on tripping hazards. At 7.0 lb (about 3.2 kg) and roughly 11.0 x 10.0 x 4.3 inches, it is much lighter and smaller than long-cord industrial reels, but it still needs a secure fixing.

Triple tap and indicator light

At the end of the cord is a grounded triple tap, so three appliances can be powered from one point. An indicator light shows that the cord is powered. It is a quick check before you start work.

Limits and breaker

The reel is rated 10A, 125V and 1250W. A built-in 10A circuit breaker cuts power if the total current of connected devices goes over 10A, and you press the breaker switch to resume. Keep to the combined limit, as the breaker is a backstop.

Who it suits

It suits a single-car garage, a hobby bench, a laundry or a small workshop where a 30-foot reach is enough and where lights, chargers, a radio or small tools are the usual load.

What to check before you buy

• Reach: only 26 feet pulls out, so measure from your mounting spot to where you work.
• Load: add up the wattage of what you will plug in, and stay within 10A and 1250W.
• Stopper: it is not adjustable, so the cord does not retract fully into the reel.
• Mounting: use solid framing and follow the supplied instructions.
• Location: check the manual for where the reel can be used; the listing does not describe wet-location use.
• Codes and manual: follow local electrical codes and the manual.

The short version

• A compact metal cord reel, model DL-600A3, with 26 ft of 16/3C SJTW cord and a 4 ft lead-in.
• Auto-guide rewind and a ratchet lock at any length.
• Grounded triple tap with an indicator light.
• 10A / 125V / 1250W limit and a built-in 10A breaker.
• 180° swivel bracket for ceiling or wall mounting.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.