Auxbeam 360-PRO 9-Inch LED Driving Lights: features, specs and who they suit

The Auxbeam 360-PRO is a set of 9-inch round LED driving lights for trucks, SUVs and other off-road vehicles. They are auxiliary lights: they mount on a bumper, roof rack or bull bar and add light on dark trails and back roads, beyond what standard headlights cast. Here is what the numbers on the listing mean and what to check before fitting them.

What the brightness figures mean

Auxbeam rates the set at 37,776 lumens, with a maximum power of 270W per light set, and says each light uses 26 P8 LED chips plus one KW3 chip. Lumens measure the total light a source emits. Two lights with the same lumen figure can look very different on the road, because the optics decide where that light goes. The brand also quotes a beam reach of 918 m (3,011 feet). Reach figures like this are typically measured to a very low light level, so usable distance on a real trail is shorter.

Spot and flood in one light

The 360-PRO combines a 30° spot beam with a 60° flood beam. Auxbeam says a centre projector lens pushes light down the road, while the wider pattern fills in the sides. In general, a spot beam suits high-speed or long-distance driving, while a flood beam helps on tight turns and slow technical terrain, where you need to see the edges of the track. A combined pattern is a compromise between the two, and it suits drivers who don't want to mount separate lights for each job.

Sealing and build

The lights are sealed to IP68, which in general means dust-tight and able to withstand continuous immersion under conditions set by the manufacturer. Auxbeam describes a sturdy housing and brackets for rain, fog, moisture and dust. Pods of this size also run warm at high power, so it helps to mount them where air can move around the housing and the manual's guidance on mounting is followed.

Wiring and installation

The set is described as plug-and-play with an included DT connector harness kit. Auxbeam says the wiring lets you install the lights in many positions on the vehicle. A harness of this type normally includes a relay and a switch, so the lights are powered through a protected circuit. Running 270W of lighting draws real current, so check that the vehicle's wiring, fuse and battery suit the load, and follow the instructions in the manual.

Who they suit

They suit owners of trucks, SUVs, UTVs and other off-road vehicles who drive on unlit roads and trails and want a strong forward and side light. They are less relevant to drivers who stay on lit streets.

What to check before you buy

• Local rules: auxiliary off-road lights are typically intended for off-road use. Check local law on lights and when they may be switched on, and follow the manual.
• Mounting space: the pods are 9 inches across, so confirm that your bumper, rack or bar has the room and a strong mounting point.
• Electrical load: confirm that your vehicle's wiring, battery and alternator suit the lights' power draw.
• Beam pattern: decide whether a combined 30° spot and 60° flood suits your driving.
• What's in the box: check the listing for the harness, brackets and hardware you need.

The short version

• A set of 9-inch round LED driving lights, model ZD000675-AB, from Auxbeam.
• Rated at 37,776 lumens and up to 270W per set, with a quoted reach of 918 m.
• A 30° spot and 60° flood beam in each light.
• IP68 sealing, with an included DT connector harness kit.
• Intended as auxiliary lighting; check local rules and your vehicle's electrical capacity.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.