VEVOR ZP-808 Electrostatic Powder Coating System: features and specs

The VEVOR ZP-808 is an electrostatic powder coating system on a wheeled base. It sprays dry powder through a gun that gives the particles an electric charge, so the powder clings to a grounded metal part. The part is then baked in an oven, which melts the powder into a hard finish. VEVOR positions the kit for factory batch work, workshops and sample testing.

How electrostatic powder coating works

In a liquid system, paint is atomised and carried by the air. In powder coating, the gun charges the powder as it leaves the tip and the charge pulls it toward the workpiece. Because the powder is held in place, it coats evenly, including around edges. The powder stays dry until the part goes into a curing oven, so a curing oven is a separate requirement that isn't part of this kit.

What the numbers mean

• 100 kV output: the voltage of the charge at the gun. Higher voltage generally means a stronger pull toward the part.
• 200 µA current: the maximum current the listing gives. Lower current settings are often used for parts with recesses.
• 50 W: the power the unit is listed at.
• 450 g/min: the powder output rate VEVOR lists, which sets how quickly a surface can be covered.
• 50 L hopper: the powder container, large enough for extended runs.

VEVOR says the strong electrostatic output improves adhesion, and that the finish resists cracking, scratching and wear. It also states that the coating is 10 times more durable than liquid coatings; that is the brand's claim and results depend on the powder, preparation and curing.

Controls

The control unit has labelled functions, and you can adjust parameters such as current and voltage. This helps when switching between flat panels and parts with more complex shapes.

Trolley base

The unit sits on a thick steel plate base with four swivel casters. Locked, the casters hold it steady while you work; unlocked, they let you move it in any direction. The listing gives the dimensions as 20.7 x 20.7 x 37.8 inches (53 x 53 x 96 cm) and the weight as 57.3 lb (about 26 kg).

Setting up for use

Powder coating needs a few things beyond the machine:

• A grounded work area and hanging point, because the part must be grounded for the powder to attach.
• Clean, dry compressed air for feeding the powder, as the manual specifies.
• Good ventilation and dust control, with protective equipment as the manual advises.
• A curing oven suited to the powder.

Follow the manual and local electrical and workplace codes for installation and operation.

Who it suits

It suits small fabrication shops, restorers, and makers who coat metal parts such as frames, brackets, wheels and shelving. Occasional hobbyists should consider the space, oven and air supply the process needs.

What to check before you buy

• Oven size: check that your curing oven fits the parts you intend to coat.
• Power supply: confirm the voltage and plug type in the manual.
• Compressed air: check the pressure and flow requirements.
• Powder: confirm that you can source suitable powders.
• Space: allow for the unit's footprint, a booth or ventilated area and parts storage.
• Upkeep: read the manual about cleaning the gun and changing worn parts.

The short version

• An electrostatic powder coating system, model ZP-808, with a 100 kV output.
• 50 L powder hopper and a 450 g/min spraying rate.
• Adjustable voltage and current from a labelled control unit.
• Trolley base with four lockable swivel casters; 57.3 lb.
• Needs a grounded work area, compressed air and a curing oven.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.