Home / Tools & DIY · Product overviews / Paint, Wall Treatments & Supplies / Paint Sprayers · More from VEVOR
VEVOR ZP-301 Powder Coating System: features, specs and who it suits
A 100 kV electrostatic powder coating kit with a 50 L hopper, 450 g/min spray gun and trolley base. What the specs mean and what to check before using powder coating.
This page contains an affiliate link, marked as such. If you buy through it, Bloiq may earn a commission at no extra cost to you.
The VEVOR ZP-301 is an electrostatic powder coating system on a wheeled trolley, with a control unit, a 50 L powder hopper and a spray gun. Powder coating is a finishing method that applies dry powder to metal parts and then cures it, usually in an oven. VEVOR aims this system at production lines, batch work and sample testing.
How electrostatic powder coating works
The gun gives the powder particles an electrical charge, and the part being coated is grounded. The charged powder is drawn to the part and clings to it until the part goes into a curing oven, where the powder melts and flows into a continuous finish. In general, this gives an even coat with less run and drip than liquid paint. VEVOR says its coating resists cracking, scratching and wear, and claims it is ten times more durable than liquid coatings; that is the brand's figure, and results depend on the powder, preparation and curing.
The headline specs
- Output: 100 kV electrostatic output, with a current of 150 µA, and a 40 W power figure in the product name.
- Hopper: 50 L, for continuous work without frequent refilling.
- Spray rate: 450 g/min, which VEVOR says gives quick application and a uniform coat.
Controls
An "intelligent mainframe" lets you adjust parameters such as current and voltage, and each function is labelled. Adjustable voltage matters because the right setting depends on the powder and the shape of the part. Recessed areas and sharp edges generally need different settings.
Trolley base
The kit sits on a thick steel plate base with four swivel casters. Lock them for stable operation, or unlock them to roll the unit through 360 degrees. The unit is about 17.6 x 17.6 x 37.0 inches (45 x 45 x 94 cm) and weighs 51.1 lb (about 23 kg).
What the kit does not include
The listing describes the spray system only. A curing oven, powder, a grounded hanging rack, a compressed air supply and cleaning materials are separate considerations.
Who it suits
It suits workshops, small fabricators and serious hobbyists who coat metal parts such as frames, brackets, wheels and furniture, and who have somewhere to cure them.
What to check before you buy
- Curing oven: you need one large enough for your parts, and it must reach the temperature the powder maker specifies.
- Air supply: check the compressor requirements in the manual.
- Grounding and ventilation: follow the manual and local codes for electrical safety, fire risk and airborne powder, and wear suitable protective equipment.
- Workspace: powder is fine and can drift, so plan a dedicated area.
- Powder: choose powders made for electrostatic spraying and cured as their makers describe.
- Part preparation: metal usually needs cleaning and degreasing for the powder to bond.
- Power supply: confirm the unit's electrical requirements.
The short version
- An electrostatic powder coating system with a spray gun, control unit and 50 L hopper.
- 100 kV output, 150 µA current and 450 g/min powder rate, per VEVOR.
- Adjustable current and voltage with labelled controls.
- Steel trolley base with four lockable swivel casters.
- About 23 kg; needs a separate oven, powder and air supply.
Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.
