VEVOR FJI-POR-50S2 12-Gallon Electric Water Heater: specs and who it suits

The VEVOR FJI-POR-50S2 is a small electric storage water heater with a 12-gallon tank, running on 120V at 1600W. It is a point-of-use unit, meant to supply hot water close to where it is needed rather than to an entire house. VEVOR designed it for small apartments, studios and remote water points.

What a point-of-use tank heater is

A whole-house water heater is typically 40 gallons or more and feeds every outlet. A point-of-use tank is smaller and sits near one or two taps, so hot water arrives quickly, without a long run of pipe. Storage heaters hold heated water in an insulated tank and keep it warm, so they can deliver hot water at a steady flow rate even with a modest heating element.

Capacity and who it serves

VEVOR says the 12-gallon tank suits one or two outlets, and has ample hot water for showers, handwashing and dishwashing for a single person or a couple. Twelve gallons is a modest volume. A shower typically uses more than a few gallons a minute, so expect limits if several taps run at once.

Heating and insulation

A 1600W element runs on a standard 120V supply. VEVOR says an extended immersion heating tube heats the water quickly and evenly. A 20 mm foam layer insulates the tank, which VEVOR says limits heat loss and keeps the temperature steady. Better insulation generally means the element cycles on less often to hold the set temperature.

Interior and built-in protections

VEVOR says the interior is enamel, resistant to high temperature and corrosion. Listed protections are dry-heating protection, overheating protection and overpressure protection, along with an IPX4 water-protection class, which means splash resistance from any direction. The listing also mentions a T&P valve, a temperature and pressure relief valve, which is a standard fitting on storage tanks.

Controls

A rotary knob sets the water temperature, and an LED indicator shows the heating status. The controls are simple, with no menus.

Size and installation

The unit measures 16.1 x 16.1 x 23.6 inches and weighs 40.1 lb empty. A full 12-gallon tank adds roughly 100 lb of water. It has a side outlet. VEVOR says it fits under sinks, in storage rooms or with booster devices, and that a manual with graphic instructions is included. Plumbing and electrical work must follow local codes and the manual. If you are unsure, use a qualified installer.

Who it suits

It suits studios, workshops, garages, cabins or small bathrooms that need hot water at one or two points, and homes where a distant main heater leaves a tap waiting for hot water.

What to check before you buy

• Hot water demand: compare your usage with a 12-gallon tank.
• Space and floor load: the unit is 16.1 inches square and 23.6 inches tall, and heavy when full.
• Electrical supply: it runs on a 120V circuit at 1600W. Check the outlet or wiring and the circuit capacity.
• Plumbing connections: check the fittings, the side outlet and the T&P valve discharge arrangements.
• Drainage: plan where a leak or relief discharge would go.
• Codes: follow local plumbing and electrical codes and the manual.

The short version

• A 12-gallon point-of-use electric storage water heater, model FJI-POR-50S2.
• 1600W at 120V, with a rotary temperature knob and LED indicator.
• 20 mm foam insulation and an enamel interior.
• Dry-heating, overheating and overpressure protections, IPX4 water protection and T&P valve.
• 16.1 x 16.1 x 23.6 inches; 40.1 lb empty.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.