VEVOR 1104A Folding Roller Stand: 2,500 lb Capacity and Specs

The VEVOR 1104A is a height-adjustable roller stand for supporting long boards, pipes and bars as they move through or off a machine. VEVOR rates it for loads up to 2,500 lb, and the base folds for storage. It is the kind of workshop helper that takes the weight of material at the end of a cut.

What a roller stand does

When you feed a long board through a table saw or planer, the far end tends to drop as it leaves the machine, which can pull the cut off line. A roller stand sits at the outfeed and holds the stock level, letting it roll out smoothly. The same idea helps when you're handling long metal pipes or bars, or when you need a support while you drill or cut them.

Matching the height

The stand adjusts from 27.6 to 52 inches (about 70 to 132 cm), which VEVOR says suits workers of different heights and a range of tools. The point is to set the roller to the same height as your machine table, or a little lower, so the work slides across rather than catching on an edge. The brand names table saws, planers and sanders as common uses.

Load capacity and build

VEVOR rates the stand at 2,500 lb and says it is built from #45 steel, a common medium-carbon steel grade. Capacity figures are typically measured under set conditions, so spread weight evenly and keep the base on a firm, flat floor. Overall dimensions are 23.6 x 23.6 x 52.0 inches (roughly 60 x 60 x 132 cm) and it weighs 29.1 lb (about 13.2 kg).

Folding for storage

To put it away, you unlock and fold the support base, which VEVOR says lets it fit into a corner. For small workshops and garages, that matters, because stands are only needed during certain jobs.

Who it suits

It suits woodworkers and metalworkers with a table saw, planer or sander, as well as anyone cutting or handling long pipes and bars. Garage hobbyists who work alone often find an outfeed support useful, since there is no second person to hold the end of the board.

What to check before you buy

• Your machine's height: make sure the 27.6 to 52 inch range covers it.
• Material: think about the length and weight of stock you work with, and use the stand within its stated capacity.
• Floor: a level, solid floor keeps the stand steady; check how the base locks.
• Space: the 23.6 inch footprint takes up room when set up, so check your workshop layout.
• Roller: look at the roller surface and length against your stock width.
• Assembly and upkeep: follow the manual for setup, locking and care.

The short version

• A height-adjustable roller stand, 27.6 to 52 inches.
• Rated by VEVOR for up to 2,500 lb.
• Made from #45 steel, 29.1 lb.
• The base folds for storage.
• For table saws, planers, sanders and long boards, pipes and bars.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.