TP-Link Omada EAP723 BE5000 Wi-Fi 7 Access Point: specs and who it suits

The TP-Link Omada EAP723 is a dual-band Wi-Fi 7 wireless access point rated at BE5000. Unlike a home router, an access point adds Wi-Fi to an existing wired network, so it is typically used in offices, shops or larger homes, often several at a time. It is part of TP-Link's Omada system for managing many devices together.

What BE5000 and Wi-Fi 7 mean

BE5000 is the combined top speed of both bands: TP-Link lists 4,324 Mbps on 5 GHz and 688 Mbps on 2.4 GHz. These are theoretical maximums. A single device usually gets far less, depending on its own Wi-Fi hardware, the distance and the walls in between.

Wi-Fi 7 (802.11be) is the newest generation. TP-Link points to two features:

• 240 MHz bandwidth: TP-Link says this supports many more simultaneous transmissions.
• Multi-RU (Resource Unit): this lets the access point divide a channel into pieces and share it among several devices, which TP-Link says keeps performance steady with multiple active devices.

To use Wi-Fi 7 features, client devices need to support Wi-Fi 7 too; older devices still connect.

The 2.5G port

The access point has one 2.5G Ethernet port. TP-Link says this unlocks the full potential of Wi-Fi 7, because a standard Gigabit port would cap wired throughput below the wireless speeds. To benefit, the switch or router at the other end should also support 2.5G.

PoE or DC power

It can be powered by PoE or by a DC adapter, but the adapter is not included. PoE sends power over the same Ethernet cable, which typically makes ceiling or wall installation simpler. Check the power standard it needs against your switch's PoE output.

Management, mesh and roaming

TP-Link lists centralized management through Omada, mesh networking and seamless roaming. Centralized management means you configure many access points from one place, and roaming lets devices move between access points without dropping connections. TP-Link also describes it as remotely managed and easy to set up.

Size and warranty

The unit is listed at 4.7 x 1.6 x 7.1 inches (about 12 x 4 x 18 cm) and weighs 0.9 lb (about 0.4 kg). TP-Link lists a five-year warranty.

Who it suits

It suits small businesses, offices and larger homes that want wired-backed Wi-Fi with central control, and people who already use or plan to use Omada gear.

What to check before you buy

• Power: confirm your switch provides the required PoE, or buy a DC adapter separately.
• Wired speed: check that your network has 2.5G to match the port.
• Client devices: only Wi-Fi 7 devices use the newest features.
• Management: decide how you'll run Omada, and check what the controller needs.
• Mounting: read the manual about placement and cabling.

The short version

• A dual-band Wi-Fi 7 access point rated at BE5000 (4,324 Mbps on 5 GHz, 688 Mbps on 2.4 GHz).
• One 2.5G Ethernet port; PoE or DC powered, with the adapter not included.
• 240 MHz bandwidth and Multi-RU support.
• Centralized Omada management, mesh and seamless roaming.
• Five-year warranty.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.