bloiq.

Guides to buying well and travelling well

Home / Tech · Product overviews / Accessories & Supplies / Mounts · More from monTEK

monTEK Ultra Slim Full Motion TV Wall Mount for 43-90 Inch TVs: specs

The monTEK US-DS-TM1003W-L is a full motion TV wall mount that folds to 0.77 inches from the wall and holds up to 143 lb. What the specs mean and what to check.

This page contains an affiliate link, marked as such. If you buy through it, Bloiq may earn a commission at no extra cost to you.

The monTEK Ultra Slim Full Motion TV Wall Mount (model US-DS-TM1003W-L) is an articulating bracket for 43 to 90 inch TVs. Its main feature is a folding design that sits just 0.77 inches from the wall, yet extends to 9.84 inches when you want to angle the screen. This page covers what the specs mean and what to check first.

Slim when folded, flexible when extended

Many full motion mounts leave a visible gap behind the TV. monTEK says this one retracts to 0.77 inches (about 2 cm), so the screen sits close to the wall like a fixed mount. Pulled out, the arms reach 9.84 inches (about 25 cm). That is a modest extension compared with long-arm mounts, which suits a TV that needs turning rather than pulling far into the room.

Swivel, tilt and levelling

The mount swivels ±30°, tilts +3° to -15° without tools to reduce glare, and allows ±3° of levelling after installation. The headline listing figure of 60° of swivel is the total range across both directions. Check that range against your seating layout before buying.

Weight, TV size and VESA

monTEK lists a capacity of up to 143 lb (65 kg) for most flat or curved LCD, LED and OLED TVs from 43 to 90 inches. VESA patterns run from 100x200 up to 600x400 mm. VESA is the standard spacing of the screw holes on the back of a TV. The brand says the thickened dual arms are steel and were tested to four times the maximum load. Confirm your TV's weight and pattern in its manual.

Walls and installation

The listing says the mount is designed for 16 or 18 inch wood studs, concrete and brick, and warns not to install it on drywall alone. Included are instructions, a bubble level, a drill template, cable clips and pre-labelled accessories, and monTEK says installation takes about 15 minutes. Decorative covers hide the screws. Allow more time if you are locating studs for the first time, and consider a helper to lift the TV.

Who it suits

It suits living rooms and bedrooms where a TV should sit neatly against the wall but still turn a little toward the seats. It is less suited to spaces where the screen needs to pull far across a room.

What to check before you buy

  • TV size and weight: 43-90 inches, up to 143 lb.
  • VESA pattern: 100x200 to 600x400 mm.
  • Wall construction: studs at 16 or 18 inches, concrete or brick. Follow the manual.
  • Reach: 9.84 inches of extension and ±30° swivel; check this reaches your viewing angles.
  • Ports: with the TV close to the wall, make sure connectors are reachable or use angled cables.
  • In the box: instructions, level, template and cable clips are listed.

The short version

  • A full motion mount for 43-90 inch TVs, up to 143 lb.
  • Folds to 0.77 inches; extends to 9.84 inches.
  • ±30° swivel, +3°/-15° tilt, ±3° levelling.
  • VESA 100x200 to 600x400 mm.
  • Template, level and instructions included; not for drywall alone.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.

Keep reading