ASUS ROG Herculx Graphics Card Holder White Edition: features and fit

The ASUS ROG Herculx White Edition is a graphics card holder: a small support that props up the free end of a large graphics card inside a PC case. Modern cards are long and heavy, and they can sag in the PCIe slot over time. This holder gives the card a second point of support and matches white PC builds.

Why a support helps

A heavy graphics card is held in place at one end by the PCIe slot and the rear bracket. The far end hangs in the air, and the weight acts as leverage. Over months the card can droop, which looks untidy and can put some strain on the slot. A holder takes some of that load. The support doesn't change performance; its job is mechanical and cosmetic.

Adjustable height: 72 to 128 mm

ASUS gives a support height range of 72 to 128 mm (about 2.8 to 5 inches). This is the distance from the base surface to the underside of the card. Cases and motherboards place the card at different heights, so the range matters: measure from the case floor, or from whatever surface the holder will rest on, to the card.

Tool-free setup

An adjustable wheel and a release button let you set and remove the holder without tools. ASUS also includes a spirit level, a small bubble level to help you get the card horizontal. That is helpful because a card that is level looks right and sits evenly in the slot.

Solid zinc alloy build

The holder is made from solid zinc alloy, a dense metal that gives a solid feel and strong support. It weighs about 0.4 lb (roughly 180 g), and ASUS lists dimensions of 8.2 x 2.8 x 0.1 inches (the listing's figures may refer to the packaged item).

Fit in your case

ASUS says the stand design is compatible with a variety of chassis and doesn't occupy PCIe slots. That distinguishes it from some support brackets that mount in an unused slot. Since the holder stands on a surface in the case, it needs a suitable flat area below the card.

White finish and ARGB lighting

This White Edition is meant to match ROG white components. A 3D ARGB element is embedded, and it works with Aura Sync, ASUS's lighting-sync system, so the colour can follow other compatible components. Controlling the light requires a compatible motherboard header and software; check ASUS's instructions.

Who it suits

It suits builders with a long, heavy graphics card, especially in a case with a glass side panel, and those who like a white or coordinated look. It is likely unnecessary with a short, light card in a small case.

What to check before you buy

• Height: measure the gap between your case floor and the card's underside, and confirm it's within 72 to 128 mm.
• Placement: make sure the floor area beneath the card is flat and clear of cables or drive cages.
• Case layout: if your card is mounted vertically, the holder may not suit it.
• Lighting connection: confirm which header the ARGB connector needs and that your board has a free one.
• Colour: this version is white, so check it fits your build.
• Contact point: make sure the holder meets the card where it won't touch fans or components, as the manual describes.

The short version

• A tool-free graphics card holder in solid zinc alloy, white finish.
• Support height from 72 to 128 mm, set with an adjustable wheel and release button.
• Includes a spirit level; doesn't use a PCIe slot.
• Embedded 3D ARGB element that works with Aura Sync.
• About 0.4 lb in weight.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.