VEVOR 2L 60W Ultrasonic Cleaner: features, specs and who it suits

The VEVOR 2L ultrasonic cleaner is a small benchtop machine that cleans items by sending high-frequency sound through a tank of liquid. It is meant for jewellery, glasses, tools, retainers and small parts that are awkward to scrub by hand. At about 5 lb, it fits on a desk or workbench.

How ultrasonic cleaning works

A transducer under the tank vibrates the liquid, producing millions of microscopic bubbles that collapse against the surface of whatever is submerged. This process, called cavitation, loosens dirt, grease and polishing residue, including in crevices a brush can't reach. VEVOR says the 40kHz frequency gives strong cleaning energy while remaining suitable for delicate parts. In general, higher frequencies are gentler, and lower ones are more aggressive.

Power, heater and timer

The unit is rated at 60W and holds 2 litres. A heater is built in with a range of 0 to 80°C. VEVOR says warming the liquid helps break down grease. In general, warm cleaning solution works faster than cold, though not every material tolerates heat, so check what you are cleaning. A digital timer lets you set a cycle and walk away.

Degassing and gentle modes

Freshly poured liquid holds dissolved air, which dampens cavitation. A degassing mode runs the unit briefly to drive that air out before cleaning begins. VEVOR describes a dual-power degassing mode that it says increases efficiency by 30% and reaches holes and crevices. The title also mentions a gentle mode, which typically reduces power for more fragile items. Check the manual for what each mode does.

Tank, basket and drainage

The tank is 304 stainless steel, a grade commonly used for its corrosion resistance. A basket keeps items off the tank bottom so they don't scratch, and a handle makes it easy to carry. A drainage system helps empty the tank without lifting it. Dimensions are 6.9 x 6.5 x 7.5 inches (about 17.5 x 16.5 x 19 cm).

What it is used for

VEVOR lists jewellery, automotive parts and eyewear. Other typical uses include small tools, watch bands, dental retainers, razors and carburettor parts. Some items should not go in an ultrasonic cleaner, such as certain soft gemstones, pearls, glued parts and some coated lenses. Follow the guidance for your specific item.

Who it suits

It suits hobbyists, jewellers, anyone who maintains small mechanical parts, and households that want a tidy way to clean glasses and accessories. At 2 litres it is not for large parts.

What to check before you buy

• Item size: confirm your largest piece fits in the basket and tank.
• Materials: check that your items tolerate ultrasound and heat.
• Cleaning liquid: use the solutions the manual recommends, and avoid flammable liquids.
• Power and placement: use a stable, dry surface near a suitable outlet, and follow the manual.
• Fluid level: check the minimum and maximum fill lines before turning it on.
• Upkeep: check how to drain, rinse and dry the tank.

The short version

• A 2-litre benchtop ultrasonic cleaner rated at 60W and 40kHz.
• Heater from 0 to 80°C, digital timer and dual-power degassing mode.
• 304 stainless steel tank, basket, handle and drainage.
• Suited to jewellery, glasses, retainers, tools and small parts.
• Check materials and fill levels before each use.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.