VEVOR MR8019 Car Dolly Rack: a rolling storage rack for four wheel dollies

The VEVOR MR8019 is a steel storage rack on casters, made to hold four wheel dollies. Wheel dollies, the low platforms used to move a car around a garage, are bulky and awkward to stack. A rack that holds them together and rolls to where the car is takes care of both problems.

What it is, and what it isn't

This is only a rack. VEVOR is clear that the wheel dollies are not included, so you'd supply your own. The rack is described as a four-dolly unit that works with most wheel dollies, including hydraulic ratchet-style dollies and jack stand organizers of a similar type. The listing doesn't name specific dolly models, so compatibility is a matter of checking your own dollies against the dimensions below.

How the dollies sit in it

The dollies are held by an insert-slot design. VEVOR gives the vertical tube height as 3.9 inches (100 mm) and the cross-section as 1.18 x 1.18 inches (30 x 30 mm). Those figures matter because they define the sockets the dollies drop into. VEVOR says the slots keep the dollies from slipping while stored. In general, a rack like this works best when the dolly's socket or post fits snugly rather than loosely.

Casters and moving it around

The rack has four swivel casters, which VEVOR describes as 360° rotatable. Swivel wheels let you steer the rack in any direction, which is handy in a crowded garage. The wheels are made of PP (polypropylene), which VEVOR says gives strong load-bearing capacity. Hard plastic casters usually roll best on smooth, level floors such as sealed concrete. They can struggle on rough, cracked or gravel surfaces.

Materials and size

The frame is Q235B steel, a common low-carbon structural grade. VEVOR calls it thick and durable. The rack measures about 31.3 x 18.8 x 8.8 inches (about 80 x 48 x 22 cm) and weighs 21 lb (about 9.5 kg) empty. Four dollies will add considerable weight, so check the dollies' own weight before loading.

Who it suits

It suits home garages and small repair shops that use several wheel dollies and want them stored in one place. If you only move a car occasionally, or have a single dolly, a rack of this type may be more than you need.

What to check before you buy

• Dolly fit: measure your dollies against the 30 x 30 mm cross-section and the 3.9-inch tube height.
• Dolly count: the rack holds four. Check whether that matches your set.
• Floor: confirm the garage floor is smooth and level enough for plastic casters.
• Weight: add up the dollies' weight and the rack's 21 lb to be sure you can roll it comfortably.
• Space: allow for its footprint of about 31 x 19 inches.
• Assembly: check the manual for any assembly steps and how the casters are fitted.

The short version

• A rolling steel rack for storing four wheel dollies; dollies not included.
• Four 360° swivel casters made of PP.
• Insert-slot design with 3.9-inch tubes and a 1.18-inch square cross-section.
• Q235B steel; about 31.3 x 18.8 x 8.8 inches and 21 lb.
• Aimed at home garages and repair shops.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.