VEVOR 6-Ton Jack Stands (HM6141C): capacity, height range and how they work

Jack stands hold a raised vehicle at a fixed height so you can work on it. The VEVOR HM6141C is a pair of red stands rated at 6 tons (13,000 lbs) and adjustable from 14.2 to 23 inches. VEVOR positions them for cars, SUVs, pickups, UTVs and ATVs.

Why a jack is not enough

A jack lifts a vehicle, but it is not designed to hold one. Standard safety advice is that a vehicle should never be supported by a jack alone while anyone is under it or working near it. Stands take the load once the vehicle is up, and the jack stays in place only as a back-up. Always follow the manual and the vehicle maker's lifting points.

Reading the capacity figure

VEVOR rates the HM6141C at 6 tons, or 13,000 lbs. The listing does not say whether that figure is per stand or for the pair, so check the product manual and markings before relying on it. In general, a capacity well above the weight on the stand leaves a margin, and you should consider the weight of the whole vehicle and how it is shared between the stands.

The brand says the stands conform to CE standards. That is a statement about the manufacturer's declaration, so read the documentation that comes with them.

The double locking design

VEVOR describes a double safety mechanism. One part is a ratchet bar with a handle-adjusted locking mechanism. The other is a set of wear-resistant metal safety pins. A ratchet bar lets you raise the stand in steps, while a pin through the post gives a second, mechanical stop that does not depend on the ratchet alone.

Base, pad and saddle

The stand has a wide pyramid base and a triangular foot pad. VEVOR says this gives a load-bearing area four times larger than before. A wider footprint generally improves stability, especially on firm, level ground. The top of the ratchet bar has a notched saddle, which VEVOR says fits the edges of the vehicle frame for a secure grip.

Materials and size

The base is carbon steel, and the ratchet bar is cast iron with a rust-proof coating, according to VEVOR. The pair weighs about 18.9 lb in total, and the packed dimensions are roughly 16.9 x 11.8 x 9.8 inches, so they fit easily on a shelf or in a toolbox.

Height range

The adjustment range runs from 14.2 to 23 inches (about 36 to 58 cm). The low end matters if your vehicle sits close to the ground. The top end sets how much room you have underneath. Compare both numbers to the height of your vehicle's lifting point when raised on a jack.

Who it suits

Home mechanics doing brake, wheel, tyre or oil jobs on larger vehicles, and owners of UTVs or ATVs, are the typical users for a capacity like this.

What to check before you buy

• Weight: confirm your vehicle's weight, and check whether the capacity applies per stand or per pair.
• Height: compare the 14.2-23 inch range to your vehicle's lifting points and your jack's range.
• Surface: use them on firm, level ground only, never on soft soil or sloping driveways.
• Lifting points: find the vehicle maker's recommended support points in the owner's manual.
• Upkeep: inspect the pins, ratchet teeth and welds before each use, and keep them dry.
• Set-up: follow the included instructions and local safety guidance.

The short version

• A pair of VEVOR HM6141C jack stands, rated at 6 tons (13,000 lbs).
• Adjustable from 14.2 to 23 inches.
• Double locking: ratchet bar with handle lock, plus metal safety pins.
• Wide pyramid base, carbon steel base and cast-iron ratchet bar.
• Supports, not lifts: use with a jack and follow the manual.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.