VEVOR LR003B Steel Loading Ramps, 1000 lb Set: features and fit

The VEVOR LR003B is a set of two arched steel ramps for rolling light vehicles and equipment up into a pickup bed or onto a trailer. VEVOR rates the pair at 1,000 lb combined and lists ATVs, UTVs, motorcycles, push lawn mowers and electric scooters as typical loads. Here is what the design features mean in practice.

What the 1,000 lb capacity covers

The capacity is a combined figure for the two-piece set, which VEVOR describes as lightweight yet strong. In general, a limit like this has to cover the vehicle's weight plus the rider or any cargo, and it is worth leaving a margin rather than loading right up to the limit. The brand itself notes that staying under the recommended capacity prolongs the ramps' service life. Check your machine's weight in its manual and compare it with the figure.

Steel construction and the arched profile

The ramps are all steel, with welded joints and a white zinc-coated surface that VEVOR says resists corrosion. The ramp surface is described as thickened and widened, which is meant to spread weight evenly and avoid bending. An arched shape typically lowers the angle at the point where a ramp meets the ground, which can help low-clearance machines avoid scraping.

Each ramp is about 76 inches (roughly 1.9 m) long and 9.8 inches (about 25 cm) wide when laid out, and the pair weighs 37 lb (about 17 kg).

Grip and securing straps

Two features aim to keep the ramps from shifting during loading:

• Rubber three-finger claw plates at the top, which grip the edge of the pickup tailgate or bed.
• Adjustable securing straps, which attach the ramps to the truck edge.

A non-slip surface pattern on the ramp helps tyres and boots find traction on the way up. As a general rule, ramps should be secured before any vehicle goes near them, and the manual's instructions should be followed for strap placement and loading angle.

Folding and carrying

VEVOR says the ramps fold or unfold in about a second, using reinforced triangular joints. A rubber handle makes each folded ramp easier to carry, and the compact folded shape is meant to fit a garage shelf or a car trunk.

Who it suits

These ramps suit owners of small powersports vehicles, motorcycles or lawn equipment who load them into a pickup now and then. They are less obviously suited to heavy machinery, as the capacity is modest, or to trailers with very high decks, where ramp length determines how steep the slope becomes.

What to check before you buy

• Vehicle weight: compare the loaded weight of your machine with the combined capacity, and leave a margin.
• Load height: measure from the ground to your tailgate or trailer deck. The higher the deck, the steeper the ramp angle.
• Wheel or tyre width: make sure your machine's tyres fit the ramp width of about 9.8 inches.
• Attachment point: confirm that the claw plates and straps suit the edge of your truck bed or trailer.
• Storage: note the folded size against the space you have.
• Upkeep: inspect welds, straps and the coating from time to time, and follow the manual.

The short version

• A two-piece set of arched steel loading ramps, model LR003B, rated at 1,000 lb combined.
• White zinc-coated steel with a widened, non-slip surface.
• Rubber claw plates and adjustable straps hold the ramps at the truck edge.
• Folds in about a second, with a rubber carrying handle.
• About 76 inches long per ramp; the set weighs 37 lb.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.