VEVOR 3 Ton Low Profile Aluminum and Steel Floor Jack: specs and fit

The VEVOR 3 ton low profile floor jack is a garage jack in aluminum and steel for lifting cars, SUVs and light trucks. It is made for tasks like changing a tyre, swapping oil or working on brakes, whether you are a professional, a car enthusiast or a weekend DIYer.

Capacity and lifting range

VEVOR rates the jack at 3 tons (6,600 lbs). The saddle starts low, at about 3.5 inches (90 mm), which is why it's called low profile: it can slide under vehicles with little ground clearance. At full height it reaches about 19.7 inches (500 mm). VEVOR says that range suits family cars, trucks and SUVs.

Dual-piston quick lift

A dual parallel pump system means two pistons raise the saddle on each stroke. VEVOR says it reaches full height in 7 strokes. Fewer strokes typically saves time, especially when the vehicle has to be raised from a low start.

Aluminum and steel build

Combining heavy-duty steel with aluminum keeps the structure strong and lighter to move: the jack weighs 64 lb and measures about 29.5 x 14.6 x 7.1 inches. It has four wheels, with two universal rear wheels for steering and rolling, and armrests on either side for carrying and positioning.

Protecting the vehicle

A rubber saddle and a foam handle bumper protect the vehicle's contact points and paint. The saddle rotates 360° and can be removed and replaced. The handle is 45 inches long, uses leverage to make lifting easier, and comes in two pieces so it can be taken apart for storage.

Standards and built-in protection

VEVOR lists compliance with CE (2006/42/EC, EN 1494 and EN 12100), UKCA (SI 2008 No. 1597, BS EN 1494 and BS EN 12100) and the ASME PALD-2014 standard. It also describes a built-in load system that avoids use beyond rated capacity, and a sealing system for long-term use.

Safe use in general

A floor jack lifts; it is not meant to hold a vehicle up. Standard practice is to place jack stands under the vehicle's recommended support points before working beneath it, and to follow the manual and vehicle handbook.

What to check before you buy

• Ground clearance: confirm your vehicle's lowest lift point is above about 3.5 inches.
• Maximum height: check that 19.7 inches is enough for the lift points on taller trucks or SUVs.
• Weight: the vehicle's weight, or the portion lifted, should be within the 3 ton capacity.
• Weight of the jack: 64 lb is manageable on wheels but heavy to carry.
• Support stands: the jack doesn't replace them.

The short version

• A 3 ton (6,600 lb) low profile floor jack in aluminum and steel.
• Lift range of about 3.5 to 19.7 inches, with a dual-piston pump reaching full height in 7 strokes.
• 360° rotating rubber saddle and a two-piece 45 inch handle.
• Lists CE, UKCA and ASME PALD-2014 compliance.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.