VEVOR Adjustable House Floor Jack Post, 54-150 in: specs and uses

The VEVOR adjustable house floor jack (model 204A-0050-00-00) is a telescoping steel post used for temporary support under beams, joists and floors. It replaces fixed lengths of timber or pipe with a post that can be set to the height you need, which is handy for basement work, levelling and construction projects.

Heavy-duty steel construction

VEVOR says the post is built from Q235 steel, a common structural carbon steel, and rates each jack at up to 11,200 lbs (about 5,080 kg). It is a telescoping design with a base plate welded to the pipe in one piece, so there is no separate plate to fix on during setup. The jack is about 54 inches long as shipped, weighs 42.9 lb and measures roughly 6 x 4 inches across.

A wide height range

The post adjusts from 54 to 150 inches (about 137 to 381 cm). That range covers anything from a low crawl space to a tall ceiling, with one post that would otherwise need several fixed-length supports. Choose a height within the stated range, and check the manual for how much of the extension the load figure covers.

Adjusting and locking

VEVOR says the height is changed by rotating a lever, with no extra tools. Multiple lock pins are provided to hold the setting. In general, a pin-locked telescoping post is meant to be set at the right length first, then fine-tuned before it takes load. Follow the manual for the correct order and positioning.

Where it fits

VEVOR describes it for temporary support in several places, including beams, patios and construction sites. Typical uses for this style of jack are supporting a sagging floor beam during repairs, holding a joist while work is done below, and levelling. Temporary means exactly that: these posts hold a load while permanent work is carried out.

Who it suits

It suits renovators, builders and homeowners tackling basement or structural repair jobs where a load needs temporary support. Where the work affects a building's structure, local building codes and a qualified professional's guidance apply.

What to check before you buy

• Height needed: measure floor-to-beam height and confirm it falls within 54-150 inches.
• Load: work out the load to be carried and compare it to the 11,200 lb capacity. Use more than one post where the manual or an engineer advises.
• Base and surface: check that the floor under the base plate is solid and level, as the manual describes.
• Length when stored: at 54 inches long, make sure you have room to transport and keep it.
• Codes and manual: read the instructions fully and follow local codes before using any support post.

The short version

• A telescoping steel jack post for temporary support, with a Q235 steel body.
• VEVOR rates it at up to 11,200 lbs, with a height range of 54-150 inches.
• Lever adjustment and multiple lock pins; welded base plate.
• Weighs 42.9 lb; intended for beams, patios and construction.
• Follow the manual and local codes.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.