VEVOR YL-15T 15 Ton Hydraulic Gear Puller: features, specs and who it suits

The VEVOR YL-15T is a hydraulic puller rated for 15 tons. A puller removes parts that are pressed or seized onto a shaft, such as bearings, gears, pulleys and hubs, without prying on them. This model comes with a case and can be set up with two or three jaws.

How a hydraulic puller works

The jaws hook behind the part, and a hydraulic cylinder pushes against the end of the shaft or a centre point. Pumping the handle builds pressure and draws the part off the shaft in a straight line. Compared with a mechanical screw puller, hydraulic force typically gives much more pulling power for the same effort. VEVOR says the included extended handle makes operation more flexible and less tiring.

Two jaws or three

The jaws can be switched between two and three. VEVOR says two jaws give stronger pulling force and suit small bearings and gears. For stability, the listing says to fit the two claws diagonally. The three-jaw layout forms a triangle, spreading the load more evenly and gripping large, heavy parts more firmly. In general, three jaws also help keep the part square, which reduces the risk of it binding as it comes off.

Capacity and reach

The listing gives a maximum pulling size of 12 inches (304.8 mm) and a maximum stroke of 2.2 inches (55 mm). The first figure is the widest part the jaws can span. The second is how far the cylinder extends in one pull. If a part needs more travel, the usual approach is to retract, reposition and pull again.

Horizontal and vertical use

The puller works both vertically and horizontally, which matters when the shaft points sideways, as with many hubs and machinery shafts, or upward or downward.

Build

VEVOR says the pump body is forged and quenched, with the oil cylinder and cover cast as one piece to prevent cracking and leaks. The whole tool is described as industrial-grade steel with a rust- and corrosion-resistant coating. It weighs 25 lb and measures 18.5 x 3.4 x 8.9 inches. The listing points to uses from workshop bearing and hub jobs to machine, railway, ship and mining maintenance.

Who it suits

It suits home mechanics and workshops that work on stubborn hubs, bearings, gears and pulleys, and small maintenance teams that want one tool to cover varying sizes. For occasional light jobs, a smaller manual puller may be enough.

As a standard precaution, follow the manual, wear eye protection and do not exceed the rated load.

What to check before you buy

• Part size: compare the part's diameter and the space behind it with the 12-inch spread and jaw reach.
• Clearance: check that the jaws can hook behind the part, and that the puller fits in the available space.
• Stroke: if the part has to travel further than 55 mm, plan repositioning.
• Weight and storage: at 25 lb with its case, it is not a pocket tool.
• Upkeep: check the manual on hydraulic oil, seals and storage, and keep the jaws clean.
• What's in the case: confirm the jaws, handle and any adapters you need.

The short version

• A 15-ton hydraulic puller, model YL-15T, supplied in a case.
• Two- or three-jaw configurations, up to 12 inches (304.8 mm) across.
• Maximum stroke of 2.2 inches (55 mm); works vertically and horizontally.
• Forged pump body and coated industrial-grade steel.
• Weighs 25 lb.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.