VEVOR HVLP Spray Gun with 1.3 and 1.7 mm Tips: features and specs

The VEVOR HVLP spray gun is a compressed-air paint gun supplied as a kit, with two fluid tips, a 1000cc cup, an air regulator with a pressure gauge and an oil and water separator. It is meant for primer, basecoat, clearcoat and touch-up work on vehicles, and for furniture, fences and walls. This page explains what HVLP means and what comes in the box.

What HVLP means

HVLP stands for high volume, low pressure. These guns use a large volume of air at low pressure at the cap to break paint into a fine mist. In general, that produces less overspray and bounce-back than conventional high-pressure guns, so more paint lands on the panel. VEVOR says the gun fully atomizes coatings with an ideal sector pattern, high adhesion and low rebound.

Two fluid tips: 1.3 mm and 1.7 mm

Tip size affects how thick a material the gun can handle. As a rule of thumb, smaller tips (around 1.3 mm) suit thinner materials such as basecoat and clearcoat, while larger tips (around 1.7 mm) suit thicker primers. The kit includes both, in stainless steel. Always follow the coating maker's data sheet for recommended tip size, thinning and air pressure.

Controls for pattern, volume and atomization

Knobs on the gun adjust the spray pattern, the fluid volume and the atomization. VEVOR says this lets you tailor the output to the job and avoid over-atomizing the paint. Practising on scrap panel or cardboard before touching the real surface is standard practice with any spray gun.

Body, cup and trigger

The body is forged aluminum with a sealed design, according to VEVOR, and the nozzles are high-grade stainless steel. The cup holds 1000cc and is aluminum. The listing describes an ergonomic grip and an easy trigger pivot, and the gun weighs about 3.0 lb (1.4 kg), light enough for longer sessions.

What is in the kit

The listing names these parts:

• Two nozzles (1.3 mm and 1.7 mm)
• A 1000cc aluminum cup
• An air regulator with pressure gauge
• An oil and water separator
• Three wrenches, a cleaning brush and three net filters
• Tape and a manual

The title also mentions an MPS adapter. The regulator and separator matter because moisture or oil in the air line is a common cause of fisheyes and blotchy finishes.

Who it suits

It suits DIY car owners doing repairs and touch-ups, hobbyists painting furniture or fences, and small workshops that want a gun with a gauge at the handle. It needs a compressor that can supply enough air volume, which is the main limit for HVLP work.

What to check before you buy

• Compressor: check the air volume (CFM) the gun needs in the manual and compare it with your compressor's output.
• Fittings: confirm the air inlet thread matches your hose and couplers.
• Coating type: match the tip size to your primer, base or clear, and follow the coating maker's guidance.
• Ventilation and protection: spraying needs good ventilation, a suitable respirator and eye protection. Follow the paint maker's instructions and local rules.
• Cleaning: solvent or thinner cleaning is needed after each use, and the brush and wrenches help with that.
• Cup size: 1000cc is a large cup, so check it suits the weight you are comfortable holding.

The short version

• An HVLP spray gun kit for primer, basecoat, clearcoat and general coatings.
• 1.3 mm and 1.7 mm stainless tips, 1000cc aluminum cup.
• Regulator with gauge and oil and water separator included.
• Adjustable pattern, volume and atomization.
• About 3.0 lb; needs a suitable air compressor.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.