VEVOR 881170A15 Outboard Throttle Control Box: features and fit

The VEVOR 881170A15 is a side-mounted remote control box for outboard engines. It holds the throttle and shift lever, the power trim switch and the emergency stop lanyard connection in one unit at the helm. This page explains what it does, what it is designed to fit and what to check before a boat owner replaces an existing control.

What a remote control box does

On a boat with a remote-steered outboard, the driver controls the engine from a lever beside the seat rather than on the engine itself. Moving the lever forward or back selects forward or reverse and then adds throttle. The box connects to the engine through a wiring harness. VEVOR designs this unit for Mercury PT 2-stroke outboard engines, so the fit is specific rather than universal.

Lever, neutral and friction

The listing says that pressing the "neutral" button switches between forward and reverse. The friction of the throttle lever can be adjusted to personal preference, so the lever stays where it is placed or moves more freely. VEVOR also mentions a low-temperature start air-fuel ratio adjustment, intended for reliable operation in cold conditions.

Power trim switch

The control lever handle has a power trim and tilt switch. Pressing the up and down arrows changes the engine's tilt angle, which VEVOR says helps when loading or stopping temporarily and keeps the engine from sitting in water for a long time. Trim also affects how the boat sits and handles under way, which the engine manual explains.

Lanyard for emergency stop

A lanyard is included. One end connects to the switch and the other attaches to the driver's waistband or wrist. If the driver moves away from the helm unexpectedly, the lanyard pulls free and VEVOR says the boat then stops automatically. Following the engine and boat maker's guidance on stop switches is standard practice.

Materials

VEVOR says the interior is an aluminum alloy (ADC2+ASA) and the housing is die-cast aluminum. The handle is ABS, which the brand describes as crack-resistant, and the buttons are listed as sturdy for frequent use.

Wiring harness

The harness is 16.3 ft (4,970 mm) long with an 8-pin and a 4-pin plug, plus a 9.4-inch (240 mm) cable for a meter connection. The insulation is thermoplastic. The listing's installation advice is to turn the ignition off, remove the key and disconnect all power and cables first.

What to check before you buy

• Engine match: confirm your outboard is a Mercury PT 2-stroke and that the plugs match your engine's harness.
• Part number: compare 881170A15 with the number on your current control box.
• Harness length: measure the route from the helm to the engine and compare it with 16.3 ft.
• Mounting: check the side-mount footprint against the space on your console.
• Gauges: see whether your instruments need the meter cable.
• Installation: follow the engine manual, or ask a marine technician if you are unsure.

The short version

• A side-mounted remote control box for Mercury PT 2-stroke outboard engines.
• Throttle and shift lever with a neutral button and adjustable friction.
• Power trim and tilt switch on the handle.
• Emergency stop lanyard included.
• 16.3 ft harness with 8-pin and 4-pin plugs; fit depends on your engine.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.