VEVOR 32-Piece E-Track Tie-Down Rail Kit: features, specs and uses

The VEVOR E-Track Kit is a set of steel rails and fittings for securing cargo in a trailer, truck bed, van, garage or workshop. The rails mount to a surface, and the fittings clip into slots along them, so you can anchor straps wherever the load needs them.

What E-track is

E-track is a standard style of slotted rail used in cargo trailers and moving vans. Each rail has evenly spaced slots, and a compatible fitting locks into a slot and can slide to the spot you need. This lets you tie down furniture, equipment, motorcycles and bikes at different positions and in different arrangements. Fittings from other makers often fit standard E-track, but confirm this for any accessory you add.

What's in the 32 pieces

The kit includes:

• 8 steel rails, 5 ft long each, with 30 slots per rail
• 8 O-rings
• 8 tie-offs with D-ring
• 8 end caps

That gives enough to run rails along both walls of a trailer or build several tie-down zones. The length of each rail is adjustable by cutting or by joining rails end to end, as VEVOR describes an adjustable length design. Check the manual before cutting.

Strength and finish

VEVOR rates the system at 1800 lbs load capacity. It says the rails are industrial-grade solid steel with a fine powder coating, which resists rust and corrosion in damp conditions. Load limits depend on how the rail is mounted and what it is mounted to, so a sturdy base and proper bolts matter as much as the rail. Strap and fitting limits are separate, and the weakest part in the chain sets the limit.

Installing it

VEVOR says a few bolts fasten the rails to vehicles, walls, floors or trailer beds and that no special tools are needed. The listing names wall, floor and bolt mounting. The bolts are not mentioned as included, so plan to buy hardware suited to your surface. For a vehicle, make sure you are fastening into solid structure, not thin sheet metal.

Where it fits

The listing names trailers, pickups, trucks and vans, plus garages, warehouses and workshops. It also suits moving a motorcycle or bikes, since you can set the anchor points to match the bike.

Size and weight

Each rail is 60 inches (about 152 cm) long. The kit's shipping weight is listed at 54.2 lb (about 24.6 kg).

What to check before you buy

• Total run length: measure your trailer or truck bed against the 5 ft rails and decide on a layout.
• Mounting surface: confirm there's solid structure to bolt into, and buy matching bolts, nuts and washers.
• Load planning: work out your heaviest load and use straps rated for it.
• Fitting compatibility: check that your straps or accessories are made for E-track.
• Hole alignment: drilling needs careful measurement before you commit.
• Space: make sure the rails don't block doors, ramps or tailgates.
• Legal limits: follow local rules on securing cargo.

The short version

• 32-piece E-track kit: 8 steel rails (5 ft), 8 O-rings, 8 D-ring tie-offs and 8 end caps.
• Rated by VEVOR at 1800 lbs; powder-coated steel.
• 30 slots per rail for adjustable tie-down positions.
• Mounts to vehicles, walls, floors or trailer beds with bolts.
• Suits trailers, pickups, vans, garages and workshops.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.