Auxbeam 7-Inch LED Headlights for Jeep Wrangler: fitment, specs and install

The Auxbeam 7-inch LED headlights are round replacement headlamps for the Jeep Wrangler and a few other vehicles that use the classic 7-inch size. They swap in for the original lamps and use LED chips instead of halogen bulbs. Below is what the specs mean and what to confirm before ordering.

What the listing says they fit

Auxbeam lists the Wrangler TJ, Wrangler LJ Unlimited, Wrangler JK (2-door), Wrangler Unlimited JK (4-door), Wrangler CJ-7, Jeep CJ-8 Scrambler, the Rubicon, Sport and Sahara trims, AM General and Land Rover Defender 90 and 110. It calls the lamps a drop-in replacement for #6014, 6015, 6016, H6024 and Par 56 headlamps. As always with fitment, check your exact model year and headlamp type against the list rather than assuming.

Light output and beam control

Auxbeam rates the lamps at 4,500 lumens on high beam and 3,200 lumens on low beam. A lumen figure describes how much light a lamp produces, and the optics decide where it goes. The brand says the lamps have a sharp cut-off line, so the low beam doesn't send light up into oncoming drivers' eyes. That cut-off is a standard feature of properly designed headlamp optics. Whatever the lamp, aim it correctly after fitting.

Build and sealing

The housing is die-cast aluminum with ribs for cooling, and the lens is polycarbonate. Auxbeam describes the lamps as rustproof, shock-proof, sealed and IP67 waterproof. In general, IP67 means dust-tight and able to handle short immersion. The ribbed design helps shed heat, which matters because LEDs lose life when they run hot.

Installation

The listing calls it a plug-and-play, non-destructive installation, usually taking about 20 minutes. Two H4 to H13 adapters and two extension wires are included, so the lamps can connect to the Wrangler's original headlight plug. Auxbeam says built-in anti-flicker circuitry stops radio interference and flickering. The package contains two 7-inch headlights, two adapters, two extension wires and Auxbeam's quality guarantee. Always disconnect the battery as the manual advises before working on wiring.

Who they suit

They suit Wrangler and classic Jeep owners who want to move from halogen to LED in the original round lamp format without cutting into the wiring.

What to check before you buy

• Model and year: match your vehicle and headlamp type to the fitment list.
• Connector: confirm that the supplied adapters match your harness.
• Regulations: the lamps are listed as DOT approved. Check local rules and follow the manual.
• Aim: adjust the beam after installation.
• Fit behind the lamp: make sure there is room for the heat-sink housing.

The short version

• Two 7-inch round LED headlights, model QPV00E59S72-CA.
• Listed for Jeep Wrangler CJ, TJ, LJ and JK, plus AM General and Land Rover Defender.
• 4,500 lumens high beam, 3,200 lumens low beam.
• Aluminum housing, polycarbonate lens, IP67 sealing.
• H4 and H13 adapters and extension wires included.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.