VEVOR Manual Wire Stripping Machine (0.06-1.5 in): features and use

The VEVOR manual wire stripping machine is a small bench tool that removes the outer insulation from cable by feeding it through a blade and roller. It is made for people who strip a lot of wire, most often when recycling scrap copper, and for whom a hand-held stripper would be slow. It can be turned by a hand crank or by an electric drill.

How it works

The cable is fed into a slot and held against a textured roller. A blade is set to cut the sheath to the right depth, and as the wire is pulled through, the insulation is split and can be peeled away from the conductor. VEVOR says the deep slot and textured roller keep the wire stable so it doesn't slip or wander during stripping. The model is listed as BXJSDK2.

Wire sizes and the four holes

VEVOR says the machine has four stripping holes and that the blade is adjustable for wire diameters from 0.06 inch (1.5 mm) up to 1.5 inches (38 mm). It lists hard-cover, soft-cover, multi-conductor and mono-filament wires as suitable. Having several hole sizes means thin and thick cable can be handled by one tool, with the blade depth set for each cable.

Visible stripping depth

The body is cast aluminium with a clear acrylic panel. VEVOR says this lets you see the stripping depth while you work, so you can adjust the blade so that it cuts the insulation without cutting into the copper. Getting that depth right is the main skill in using any stripping machine.

Blade

The blade is made of 65Mn spring steel, which the listing describes as strong and hard. Spring steel of this type is common in blades because it keeps its edge yet resists breaking. Like any blade, it will dull over time.

Hand crank or drill

Two modes of operation are described. The supplied crank handle lets you work by hand, including when there is no power. For heavier volumes, the machine can be connected to an electric drill to reduce hand fatigue. If you use a drill, start slowly, keep fingers away from the moving parts, and follow the manual on speed.

What's in the box

VEVOR includes a pair of gloves and instructions that include tips on the stripping angle. The machine itself is small, at 5.1 x 5.1 x 0.1 inches on the listing, and weighs 8.2 lb (about 3.7 kg), which makes it easy to carry or bolt to a bench.

Who it suits

It suits scrap collectors, recyclers, electricians and hobbyists who handle batches of cable. For occasional single wires, a hand stripper is usually enough.

What to check before you buy

• Cable type: check the diameters and constructions you plan to strip against the listed range.
• Mounting: decide whether you will clamp or bolt it to a bench.
• Drill: if you plan to use one, check that the chuck fits the drive shaft.
• Protection: wear gloves and eye protection, and keep clothing and hair clear.
• Live wires: only strip cable that is disconnected and de-energised.
• Local rules: check any rules on handling and recycling scrap cable.

The short version

• A manual wire stripping machine, model BXJSDK2, for wire from 0.06 to 1.5 in.
• Four stripping holes and an adjustable blade.
• Cast aluminium body with a clear acrylic panel to see stripping depth.
• Hand crank or electric drill operation.
• Gloves and instructions included; 8.2 lb.

Bloiq is reader-supported. Some links may earn us a commission; it never affects what we write. How we make money.